|
Small amplifier (mono) with potentiometer. Replaces old separate amps of your vintage Universal game PCBs like Mr. Do and Lady Bug and makes them working in your new Jamma ... more |
$4.47
|
|
|
Converts CGA signal (RGB, 15 kHz) into Video (RCA jack) and S-Video (mini-DIN connector) - switchable to PAL or NTSC format. With 3 potentiometers (R-G-B) for colour adjust... more |
$49.79 $41.82
|
|
|
Converts VGA signals (640x480, 800x600 and 1024x768 pixel) into a CGA signal (15.7 kHz, CSync), Composite Video or S-Video (observe jumper settings). With 6 buttons for pos... more |
$84.91 $69.73
|
|
|
The Ultimate Video card for 15 or 25 kHz Arcade Monitors. Connect your arcade cabinet monitor or an ordinary PC monitor to your PC with no special configuration in either D... more |
$108.70
|
|
|
Small amplifier (stereo) with potentiometer for speaker with an impedance of 8 Ohm. Needs 12 Volts, power: 2 x 5 Watt. Input (con2) from left to right: left, GND, right. Su... more |
$9.01
|
|
|
Standalone video amplifier which converts the 1 Volt output from a VGA card into a 5 Volts video RGB signal required by most arcade monitors. This amp is designed to be con... more |
$32.80
|
|
|
Converts any CGA signal (15 kHz RGB) into a 31 kHz VGA signal (VGA jack). Switchable to VGA bypass. Sync can be combined (CSync) or separated (HSync + VSync). With 3 potent... more |
$79.24
|
|
|
DVI to VGA adaptor. Required for simultaneous connection of PC VGA/SVGA monitors besides your Arcade monitor to an ArcadeVGA 2. Not required for arcade monitors nor DVI LCD... more |
$9.91
|
|
|
Scanline generator with power supply unit for any RGB scart device gives your brand new TV set a vintage touch. With on/off switch. Scanline intensity adjustable from 1 to ... more |
$45.26
|
|
|
The SLG3000 generates scanlines as known from older picture tubes (in tv sets and amusement machines) at resolutions of 640 x 480 and 800 x 600 pixels. Choose your preferre... more |
$47.52
|
|
|
This EDID dongle makes your new generation graphic card work with the small tool Soft-15kHz. Now benefit from a high power graphic card for your MAME setup - including low ... more |
$19.82
|
|
|
Slim shielded speaker for Arcade cabinets. Power: 10 Watt, resistor: 8 Ohm, diameter: 58 mm x 127 mm (2.280 x 5 inch). Breadth of terminals: 4.8 mm (0.187 inch) and 2.8 mm ... more |
$9.01
|
|
|
Typical speaker for Arcade cabinets. Power: 5 Watt, resistor: 8 Ohm, diameter: 102 mm (4.016 inch). Breadth of terminals: 4.8 mm (0.189 inch).... more |
$4.47
|
|
|
UMSA connects your computer to a CRT TV set featuring a RGB Scart interface. Just make sure that your PC outputs VGA lower resolution with 15 kHz. You can enable this frequ... more |
$40.73
|
|